When I set my multipliers on 10 or 10.5 it shows 9.5,but the rest work fine,any ideas?
It is unlocked and never has been any problems always worked fine,did I burn up my CPU?
Well I redid it and everything is working except the 10 multiplier..\
but I found one of the pads on my CPU seems to be falling apart,is there a quick fix for this
Im talkng about thelittle foam tab on each corner of the CPU.
In fact that was the problem one closest to the L1 was worn so bad I thing the heat sink may have been close enough to short it out,but anyway it seems to be ok now,I want to thank you guys again for the help,were would I be with out you guys...
Id be throwing a lot of ruined parts in the trash most likely
Thanks guys
i think super glue would work fine.. or just tape it back.. ive seen in a thg video and they taped their little pad back on in the unlocking a XP video..
or i think u might be able to take all 4 off and buy a shim.. but dont do this first as im not sure how it will work.. just a idea..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.