Results 1 to 3 of 3
  1. #1
    Member roYal's Avatar
    Join Date
    Jun 2002
    Location
    Chicago, IL
    Posts
    1,394

    my 4-pin panaflo

    I have the antec plus1080b. It has some fan-only molexes from the psu. These fan-only connecters are for fans only and not electrical componenets. I have the panaflo h1a 4-pin fan for my heatsink. How should i wire it up? Should i hook it up to the fan-only connecter and then hook it up to a 3.5/5.25 device, or should i hook it up to a regular molex (non fan-only connecter)?

    Also, will my fan work if i hook it up to a fan-only connecter and then not hooking it up to a 3.25/5.25 device?

    Also, if i hook up the fan to a regular molex (non fan-only connecter), will my fan work at the highest speed it can for optimal cooling?

    What should i do?

  2. #2
    Member The Spyder's Avatar
    Join Date
    Mar 2002
    Location
    Oregon
    Posts
    2,319
    I think the NORMAL molex connector is your best bet here for maximum cooling- infact the other fan only may slow it down-
    SPyder

  3. #3
    Member roYal's Avatar
    Join Date
    Jun 2002
    Location
    Chicago, IL
    Posts
    1,394
    yes, i just read my manual, it sais connect to regular molex for maximum cooling, however noise wont be reduced. IN this case, the fan for the heatsink is very important, so i'm gonna connect it to a regular molex.
    Thanks.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •