Hey guys.
I have a PSU that is installed at the bottom of a case, so when I route the SATA power connectors up the bottom to the hard drive chassis, the connectors are upside down. I was wondering if I could simply install the harddrives upside down to get around this small annoyance? I obviously don't want to do any kind of harm to the drives, but I figured it may be possible since some cases have you install them on their sides with no troubles.
The drives in question are a pair of 1TB WD Blacks, if that even makes a difference.
Thanks!
I have a PSU that is installed at the bottom of a case, so when I route the SATA power connectors up the bottom to the hard drive chassis, the connectors are upside down. I was wondering if I could simply install the harddrives upside down to get around this small annoyance? I obviously don't want to do any kind of harm to the drives, but I figured it may be possible since some cases have you install them on their sides with no troubles.
The drives in question are a pair of 1TB WD Blacks, if that even makes a difference.
Thanks!