- Joined
- May 11, 2005
just installed my old IC7 into my new Thermaltake case. After hitting the power button, about 10 sec go by and I hear a long continious beep. It lasts for about 5 sec, then goes off for about 5 sec and repeats this cycle.
When turned off with power supplied to it, the green LED light at the bottom of the mobo is on. When powered on, there is a red LED that comes on. I'm not sure if that's normal, but I don't think it's good.
I checked out the post codes on abit's website, but I really don't understand them.
Could this be a case of grounding? I used the small brass spacers to mount the mobo and that went off w/o a hitch.
I did read a similar post: http://www.ocforums.com/showthread.php?t=493431&highlight=ic7+post
I seem to be having the same error as him, same symptoms
The Video card works fine aswell as the RAM. I even pulled all the RAM from the board and tried it, but got the same red LED and long beep.
Going to try and remove all pci cards and gfx card, RAM and 1 hard drive.
Any suggestions are greatly appriciated.
When turned off with power supplied to it, the green LED light at the bottom of the mobo is on. When powered on, there is a red LED that comes on. I'm not sure if that's normal, but I don't think it's good.
I checked out the post codes on abit's website, but I really don't understand them.
Could this be a case of grounding? I used the small brass spacers to mount the mobo and that went off w/o a hitch.
I did read a similar post: http://www.ocforums.com/showthread.php?t=493431&highlight=ic7+post
I seem to be having the same error as him, same symptoms
The Video card works fine aswell as the RAM. I even pulled all the RAM from the board and tried it, but got the same red LED and long beep.
Going to try and remove all pci cards and gfx card, RAM and 1 hard drive.
Any suggestions are greatly appriciated.
Last edited: