Notices

Overclockers Forums > Hardware > Storage
Storage SSDs, HDDs, CD/DVD/Bluray
Forum Jump

New SSD Concerns!

Post Reply New Thread Subscribe Search this Thread
 
 
Thread Tools
Old 06-30-12, 03:47 PM Thread Starter   #1
Maximilian098
Registered



Join Date: Dec 2011

 
New SSD Concerns!


Hey Overclockers! ^.^

I have two concerns that come to mind, since now i finally have some money set aside, and prices have come down, for me to purchase an SSD.

My first issue is the issues with my Motherboard. I have Gigabyte X58a-UD3R (Rev. 2). This board has a Marvell SE9128 SATA 3 Controller, and from what I hear, there are quite a few issues with controllers such as as these. When purchasing my SSD, should I, 1). purchase a SATA 3 PCIE Card for my computer (they run as low as 15 bucks on amazon), should I just use Sata 2 port, or will I most likely be fine as is, or will it just be flat-out not compatible. If anyone that has a similar build as mine, and use an SSD, or if you just know about this situation, any light shed on this concern would be much appreciated!

My second issue, is that I cant decide which SSD to choose!
Right now i'm stuck between a Corsair GT (120GB) and an Intel 330 (120GB), the intel is 10 bucks more, and apparently is slower on the read write times, while on the other hand, people notice more real-world performance on them over the corsair model. Or will these SSDs conflict considering my problem stated above? Opinions, (or entirely different SSDs) are welcome, and any advise, is again, very appreciated!
Maximilian098 is offline   QUOTE Thanks
Old 06-30-12, 04:29 PM   #2
Knufire
Senior Member

 
Knufire's Avatar 

Join Date: Feb 2010
Location: Terre Haute, IN

 
Can't get a better deal than the Agility 3 right now.
Knufire is offline Benching Profile Heatware Profile   QUOTE Thanks
Old 06-30-12, 06:20 PM   #3
Psykoikonov
Member



Join Date: Dec 2003
Location: ON, CA

 
Any SATA3 controller you can pickup will likely exhibit the same issues as the onboard or worse, the Intel onboard SATA2 port will be your best bet. SSD's shine because of their extremely low access time compared with an HDD, not so much because of their speed.

As for the SSD to choice I would go Intel all the way, their reliability is second to none.

__________________
Heatware (10-0-0)
Psykoikonov is offline   QUOTE Thanks
Old 06-30-12, 08:32 PM   #4
Cigarsmoker
Member



Join Date: Jul 2011
Location: Calgary, Alberta, Canada

 
The Crucial M4 uses a Marvel controller so there should be no conflict. I've owned a Corsairs Force 3 120 GB, Crucial M4 and just picked up a Vertex 3 120 GB for $89. No comment on the Vertex 3. The Corsairs gave me nothing but trouble until I moved it to a SATA II only system. The Crucial have been great from day one.

Last edited by Cigarsmoker; 06-30-12 at 09:03 PM.
Cigarsmoker is offline   QUOTE Thanks
Old 06-30-12, 08:38 PM   #5
Janus67
Benching Team Leader
Wannabe Admin Senior

 
Janus67's Avatar 

Join Date: May 2005
Location: Ohio State

 
There won't be a compatibility issue, you just have to note that the Marvell sata3 controllers do not give as high of speeds as the integrated Intel ones.
Janus67 is offline Author Profile Benching Profile Folding Profile Heatware Profile   QUOTE Thanks
Old 07-01-12, 10:03 AM Thread Starter   #6
Maximilian098
Registered



Join Date: Dec 2011

 
I'm looking into a bunch of these hard drives everyone has suggested, and considering my situation, would it be best to get a Marvell-based SSD if I intend to use the sata 3 port on my motherboard? Will it cause conflicts of I don't, or are these original Marvell sata3 ports really that bad that sata 2 will be better?
Maximilian098 is offline   QUOTE Thanks
Old 07-01-12, 12:12 PM   #7
Psykoikonov
Member



Join Date: Dec 2003
Location: ON, CA

 
A quick search says that the latest Marvell SATA 3 driver is much better with SSD's than previously, once you receive your SSD it wouldn't be hard to plug it in to both ports (Marvell and Intel) and test using your old install before installing the OS to the SSD. A Marvell based SSD won't perform better or worse than another SSD using it, it never was really a conflict so much as poor performance from the Marvell SATA 3 ports from what I've read.

__________________
Heatware (10-0-0)

Last edited by Psykoikonov; 07-01-12 at 03:48 PM.
Psykoikonov is offline   QUOTE Thanks
Old 07-01-12, 03:47 PM   #8
Archer0915
"The Expert"

 
Archer0915's Avatar 

Join Date: Nov 2008
Location: East Carolina University Grad School

 
Mushkin and they have SandForce controllers.

__________________
People that buy OEM systems think Linux was a Charlie Brown character, a registry is something you see at target to buy shower gifts, RAM is a Dodge truck and a hard drive is DC at rush hour.
Knowing your usage habits can help you save money and get the fastest system for you!

Current Active Fleet:
Daily Driver - i7@3.8, 16GB Ram, 6770 GFX Bedroom PC - SB Celerey @ 1.6, 4GB Ram
Entertainment Room HTPC & Madia/File Server - 661@3.5, 4GB Ram, On Chip GFXLiving Room HTPC - E-450@1.9 GHz, 4GB Ram

Game Rig - 2500K@4.5, 12GB Ram, 465GTX + 9800GT (PhysX) using intel SRT
Test Bed - 3570K with various components and a TT 750w PSU
Archer0915 is offline Author Profile Benching Profile Heatware Profile   QUOTE Thanks
Old 07-01-12, 04:10 PM   #9
txus.palacios
Premium Member #18

 
txus.palacios's Avatar 

Join Date: Dec 2011
Location: Cádiz (Spain)

 
If you can afford them, go Intel always.

And the SATA3 PCIe card and the Marvell SATA-600 controller, IMHO, is six and half a dozen.

__________________
Maximus V Gene | i5-2500k @ 4.5GHz (ekHF) | 16GiB | GTX470 SLI @ 800MHz (ekFC) | m4 128GB | Arch + Win8
[ more info... ]


The only sound I want to hear out of my computer (unless I'm gaming or watching a movie) is the hum of my 6000 rpm fan pushing air through my heatsink. - Seebs
If I turn up dead, somebody make sure they put "should have just benched in the cold" on my tombstone, along with my most recent superpi32m score. - I.M.O.G.
I didn't go water-cooling for an air-cooling Vcore!! - bluezero5
I'll rm -rf /yourface/* - thideras
txus.palacios is offline Benching Profile Folding Profile   QUOTE Thanks

Post Reply New Thread Subscribe


Overclockers Forums > Hardware > Storage
Storage SSDs, HDDs, CD/DVD/Bluray
Forum Jump

Thread Tools Search this Thread
Search this Thread:

Advanced Search


Mobile Skin
All times are GMT -5. The time now is 04:56 AM.
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
You can add these icons by updating your profile information to include your Heatware ID, Benching Profile ID or your Folding/SETI profile ID. Edit your profile!
X

Welcome to Overclockers.com

Create your username to jump into the discussion!

New members like you have made this the best community on the Internet since 1998!


(4 digit year)

Why Join Us?

  • Share experience
  • Max out your hardware
  • Best forum members anywhere
  • Customized forum experience

Already a member?