• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

ocz platrevis2 autodetects @ 2-3-3-5 1T?

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

siresword

Member
Joined
Jul 11, 2005
Location
maryland
i just built my new system, and i haven't really played with it yet, but when it starts up it tells me that my ram (2x512 ocz el plat revis 2) is at 1T 2-3-3-5, 200mhz

the defaults are 2-2-2-5, should I manually set it ? isn't it supposed to auto detect?
oh and uhh im using the orange slots, the yellows wouldn't boot
 
In case you're interested :)

DFI NF4 (all), Venice, San Diego or Winchester 90nm and OCZ TCCD/TCC5 memory, 200mhz memory clock 1:1 with HTT speed.

In DRAM Configuration Section of Genie BIOS:

200
enable
2.0
02
07 or 8
02
07 or 8
16 or 14
03 or 02
03
02 or 01
03 or 02
3120, 4708, 0648, or 2560 (4708 works well at high overclocks)
auto
enabled
auto
0
level 6, 5 or 7
auto
DRAM Response Time: fast or normal (as needed if your BIOS has this feature.)
auto
256
disable
16
07
disable

In Genie Bios:

200
auto
16 16
auto
100
disable
1.500
1.25v (This is about 1.52v, if you need more or less, please adjust, but do not go past 1.45v here, use more the 123% below, there is a reason )
above VID * 123%
1.30v
1.70v
2.8v (2.7v-3.0v may work for you, depending on final speed)

Loosening the memory timings to 2.5-3-3-8 or 2.5-4-3-8 will get you a good overclock, as will 2.5-4-4-8. For clarification, 2.5-3-3-8 will show up as 2.5-3-8-3 in the BIOS.
 
Back