• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

Fastest Barton Thread.

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

{PMS}fishy

Senior Member
Joined
Dec 20, 2001
Post your fastest screen CPU-Z/WCPUID/GCPUID

Get GCPUID here, made by our own Coolest.

http://forum.oc-forums.com/vb/showt...threadid=184363

Rules:

Post only 1 time.

Edit your post if something needs to be changed.

No comments in this thread. PM the user or create a new thread if there are any questions.

Please also list any specs that are important.

I don't care if its stable or not, lets just see some high screen shots.

I just went a fiddled with mine really quickly, Ill take it easy at first, then Ill pour on the heat if need be.

Speed.jpg



Info:

Custom Water cooling.
IQYFA 0343 MPMW
2.1v on Lame NF7
 
Last edited:
OK here's mine. I don't know the steppings, I didn't really care much about it so I didn't look before I installed the CPU. Well, I don't want to take off the heatsink just to find that.
 

Attachments

  • cpuz.jpg
    cpuz.jpg
    49.1 KB · Views: 888
mem voltage holding me back...

Stepping - IQYFA 0343 MPMW
 

Attachments

  • 2706.jpg
    2706.jpg
    46 KB · Views: 845
Last edited:
This was at 2.1V on the 2500+ I had a couple weeks ago... room temp 10C (1.6V was the chipset voltage... it's no miracle chip):
latest.jpg
 
Last edited:
{PMS}fishy said:


Rules:

Post only 1 time.

Edit your post if something needs to be changed.

No comments in this thread. PM the user or create a new thread if there are any questions.

 
Last edited:
{PMS}fishy said:


Rules:

Post only 1 time.

Edit your post if something needs to be changed.

No comments in this thread. PM the user or create a new thread if there are any questions.


Umm..yeah... what ^he^ said. :D

(thread cleaned as requested by {PMS}fishy)

B.
 
m-barton 2400+


only 45mhz better than my tbred.


DIY phase change cooled; below 0C @ idle @ 2,956mhz @ 1.96v



2956mhz_barton.png
 
Sorry this is not a screen shot. Delete this post if needed after a while.

I suggest at least add some key info for each screen shot.

1. CPU details such as 2400+, 2500+, 2600+ (I suppose only mobile barton here)

2. Stepping such as IQYFA 0343 MPMW

3. Cooling setup such as air (HS, fan), water (water block), chilled water, phase change, ....

4. Vcore, CPU temperature (at least light load temperature)
 
Here's mine: 2901MHz, not stable.
SP97 /92mm Datech fan (bypassed thermal sensor)
Lian-Li PC-75 - side panels off, open window

I may be able to get it to go a little higher.
 

Attachments

  • 2901.jpg
    2901.jpg
    57.1 KB · Views: 508
Last edited:
Back