- Joined
- Apr 20, 2010
hey everyone, a friend talked me in to cutting out his gamer tag into the side of his HAF 932. I looked up the case and it's made of steel. I was wondering if the Dremel 7700 would be the proper tool to use for this, because it's all he has. I tried cutting out the "M" on the design but its a pretty thick side panel and am a bit worried im going to break either the dremel or ruin the side panel. I have been looking around to see if this dremel is worthy of doing this job, but have yet to find anything on the subject.
Any help/advice is greatly appreciated.
Any help/advice is greatly appreciated.