Easiest tool for cutting

RnPgrosz · 10-03-02, 06:58 PM

Hey guys,

I want to cut a hole for a 120mm fan in the front of my case(Lian Li PC71). I was wondering what the best/easiest tool for this job would be. I do have a dremel but I'm not sure how well that would work. Thanks

o0OBruceLeeO0o · 10-03-02, 07:02 PM

a hole saw, especially if you already have a drill. If you dont already have a drill it may be a waste to get it for just 1 job. I never see hole saws measured in mm but I beleive 4.5 inches = 120mm (yoou may wanna double check though) . Good luck!

stool · 10-04-02, 08:08 AM

Do you mean the plastic front bezel or the metal on the carcass?

10-03-02, 06:58 PM	Thread Starter #1
RnPgrosz Member Join Date: Dec 2001 Location: NJ	Easiest tool for cutting Hey guys, I want to cut a hole for a 120mm fan in the front of my case(Lian Li PC71). I was wondering what the best/easiest tool for this job would be. I do have a dremel but I'm not sure how well that would work. Thanks
	QUOTE Thanks

10-03-02, 07:02 PM	#2
o0OBruceLeeO0o Member Join Date: Aug 2002 Location: Charlotte, NC	a hole saw, especially if you already have a drill. If you dont already have a drill it may be a waste to get it for just 1 job. I never see hole saws measured in mm but I beleive 4.5 inches = 120mm (yoou may wanna double check though) . Good luck!
	QUOTE Thanks

10-04-02, 08:08 AM	#3
stool Senior Member Join Date: Dec 2000 Location: Albany, NY	Do you mean the plastic front bezel or the metal on the carcass? __________________ My Heatware
	QUOTE Thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search

Easiest tool for cutting

Internet Services

Website Development

Tech Hardware