Card: MSI Ti4600 with voltagemod (580 Ohm : 1.95V)
Cooling: 80W pelt + WC
--------------------------------------------------------------------
For about 6 months the card worked fine at 370 Mhz.
Since a few days I had to remove the voltage mod
because of lockups. When I OC without the Vmod I
can go to 345 no problem (100% stable), any higher
no crash but the 3D gets corrupted and very slow.
But with the Vmod the card doesn't even run 3D at
300 Mhz. Even when I raise the resistor -> lower the
voltage to 1.75V I can't run any 3D. I redid the mod
a few times.
Has anybody got an explenation why I have problems with
the Vmod??? It jused to work fine...
The card is very well isolated so there is no condensation or heat problem.
Cooling: 80W pelt + WC
--------------------------------------------------------------------
For about 6 months the card worked fine at 370 Mhz.
Since a few days I had to remove the voltage mod
because of lockups. When I OC without the Vmod I
can go to 345 no problem (100% stable), any higher
no crash but the 3D gets corrupted and very slow.
But with the Vmod the card doesn't even run 3D at
300 Mhz. Even when I raise the resistor -> lower the
voltage to 1.75V I can't run any 3D. I redid the mod
a few times.
Has anybody got an explenation why I have problems with
the Vmod??? It jused to work fine...
The card is very well isolated so there is no condensation or heat problem.