[jbox33]

I'm finally going to put together a watercooled setup and I am trying to figure out how to put it in my case.

I was wondering if it would be a bad idea to put a 90 degree fitting on the outlet of my pump. It's a Eheim 1250.

If it will affect my flow too much I won't do it but if I can then I have a great place to put it.

[Chaos2358]

I recently redid my setup, it's all in case and I used like six 90 degree fittings which didn't seem to affect anything negatively. They make for a better fit in my case and my temps are about the same if not slightly cooler. The fittings shouldn't affect the flow rate too much if at all.

[jbox33]

That's good to know Chaos thanks. Now I can put it in the removeable 3.5" drive bay with a little modification. The pump fits perfectly in there.

And if it doesn't work out I can always change it. Wasn't sure if I should do it because of all the pics posted on here I don't remember seeing any pumps with a 90 right out of the outlet of the pump.