Hi guys,
I just received my new Antec True Power 480W;
I replaced it, connected all my hdds and dvds and stuff, and booted up. It only detects primary master and slave. If I disconnect one of the secondaries, it detects the other, which would sound like not enough power to me unless I knew it was 480W... anyways, that doesn't really worry me too much right now, I'll figure it out later. What does worry me is that I booted into windows and now both my load and my idle temps are about 10C higher! What can that be caused by? I have a watercooling system, and my pump is connected to the ps...?? I can't really explain this.. the water is cool to touch... help!
I just received my new Antec True Power 480W;
I replaced it, connected all my hdds and dvds and stuff, and booted up. It only detects primary master and slave. If I disconnect one of the secondaries, it detects the other, which would sound like not enough power to me unless I knew it was 480W... anyways, that doesn't really worry me too much right now, I'll figure it out later. What does worry me is that I booted into windows and now both my load and my idle temps are about 10C higher! What can that be caused by? I have a watercooling system, and my pump is connected to the ps...?? I can't really explain this.. the water is cool to touch... help!