- Joined
- Dec 24, 2002
I wan't to try to make a turbo.pll for the p4t533-c
I found DIY at vr-zone and kavut. (Good pics)
The problem is that this also overclocks the 48mhz signal.
Leaving USB inoperative. I don't see a 24 mhz signal generator on the pll chip.
All the p4t(e,c,r) MB us an ICS9250-37 pll clock generator.
www.ICST.com
This chip looks like it uses 4 pins for the 48mhz signal generator
pin 24 -ground
pin 25 -48mhz 0
pin 26 -48mhz 1
pin 27 -3.3v
Do you think it will work, if i just solder 25/26 with wires to the MB with the resistors pulled and power and ground 24/27?
I found DIY at vr-zone and kavut. (Good pics)
The problem is that this also overclocks the 48mhz signal.
Leaving USB inoperative. I don't see a 24 mhz signal generator on the pll chip.
All the p4t(e,c,r) MB us an ICS9250-37 pll clock generator.
www.ICST.com
This chip looks like it uses 4 pins for the 48mhz signal generator
pin 24 -ground
pin 25 -48mhz 0
pin 26 -48mhz 1
pin 27 -3.3v
Do you think it will work, if i just solder 25/26 with wires to the MB with the resistors pulled and power and ground 24/27?