Need some help w/ my 2100+ 0250

toxik co2 · Feb 9, 2003

Well i'm running 12x198 @ 185v on a Asus A7N8X non-Deluxe with 1001.E BIOS and my Corsair XMS3200 at Sync and 5-2-2-2.5T timing's on 2.6v and after running Prime95 for awhile I get this.... It seems this chip doesn't not want to his 2.4ghz no matt what why I try it. I could only get to 13x183 @ 1.85v before I unlocked the processor. Doesn't anyone have any ideas it takes almost 2 hours for it to crash usually when I have a unstable OC Prime95 crashes within 5 minutes.

l0rd_tornado · Feb 9, 2003

Have you tried pushing your voltages a little higher?

toxik co2 · Feb 9, 2003

My BIOS only supports 1.85v and i'm not too sure how much I like the voltage mod....I don't think I understand it enough.

Decaf · Feb 9, 2003

I'm guessing you're maxed out on vcore. How about a volt mod? Can you boost your vdimm?
You didn't say anything about your temps?
Do you have a good power supply?

The difference between a 5 min p95 crash and a 2 hour crash is a matter of degrees. It just means your close to stability but not quite there.

Mugen1516 · Feb 9, 2003

try 2.7v or 2.8v on your vdimm (DDR). I'm doing 193 with the same hardware as you. check my sig. I just completed a 24hr prime95 session. Passes memtest too.

toxik co2 · Feb 9, 2003

I'm water cooled i've never seen a temp above 40C under full load even days of Prime95. I will see how a raise in DDR Voltage does and post back. I have a Antec True430w. My cooling and Power Supply should have no problems they will handle whatever I can throw at them.

R4z0r4mu5 Pr|m3 · Feb 9, 2003

sounds like your cpu-oc has hit a brick wall (can't expect speed to go up forever), try burning in more and be patient, that's already an awesome oc imo

toxik co2 · Feb 9, 2003

Mugen1516 said:
try 2.7v or 2.8v on your vdimm (DDR). I'm doing 193 with the same hardware as you. check my sig. I just completed a 24hr prime95 session. Passes memtest too.

I put my DDR Voltage at 2.7 and i've had Prime95 stable for over 2 hours now

thanks Mugen

OrangUtan · Feb 10, 2003

Got a AIUHB 0303
Doing 2400mhz
133*18
2.0Vcore
2.85V DDR
PC3500 Cosair XMS3500 512MB
Abit KD7 RAID
Ambient Temp: 30-34c
Heatsink: Alpha 8045 with Delta Focusflow EHE 1.35a

166mhz crashes on me. Cant even post.

Mugen1516 · Feb 10, 2003

Can't post at 166Mhz at any multi?

Need some help w/ my 2100+ 0250

toxik co2

Member

l0rd_tornado

Member

toxik co2

Member

Decaf

Member

Mugen1516

Member

toxik co2

Member

R4z0r4mu5 Pr|m3

Member

toxik co2

Member

OrangUtan

Registered

Mugen1516

Member

Similar threads