- Joined
- Dec 16, 2002
- Location
- Canyon,Tx.
Ok, i have the equipment in my sig below....
Now this is ddr400 ram, it should run at 200 FSB right? At normal 11.5 i can set the memory to SPD and it post's as 200 mhz.
If i set it to 100% and run it at 10x190 this should only be 380mhz.
Ok, 2 days ago i totally corrupted windows, and now i even get a "system failed memory test" when i boot. Yet it still continues to boot and runs xp fine...
Why will it run at default 11.5x133 SPD which is 200 but seems to have fried it at 10x190?
Did i just burn it ya think? It never did really like running at 200 though. Best i could get was like 7.5x200
Guess it's time to change my sig again...
Now this is ddr400 ram, it should run at 200 FSB right? At normal 11.5 i can set the memory to SPD and it post's as 200 mhz.
If i set it to 100% and run it at 10x190 this should only be 380mhz.
Ok, 2 days ago i totally corrupted windows, and now i even get a "system failed memory test" when i boot. Yet it still continues to boot and runs xp fine...
Why will it run at default 11.5x133 SPD which is 200 but seems to have fried it at 10x190?
Did i just burn it ya think? It never did really like running at 200 though. Best i could get was like 7.5x200
Guess it's time to change my sig again...
