WTF???!! now I need some serious help here! :((

Ahhrg. something awful has happened.
Got my NF7 rev1.2 the other day and I started testing what this board was good for.

So finally I was running 210*11 and that was descent.
Then I tried to max the cpu so I put the vcore on 1.85 and rebooted.
Nothing......ok
So I cleared cmos and begun all over again.
But now something has gone seriously wrong.
Now after jumping the vcore to 1.85 I cant even run 180fsb.
And my cpu cant do anything over 1800mz.
But before i tried 1.85 it was running 2300mhz!!

So plz help me. Im really ****ed right now
How can a single setting like vcore just screw up my brand new board?

Or is it something else?
I have a lousy noname 450W PSU
Can that be the little problem..

help me

According to the an article on the Inquirer, there's a problem with the nForce2 boards and higher FSB's. The short and skinny of it is that if the board has a hiccup at a high FSB, it reverts back to its 100 MHZ FSB setting and a true 100 MHz CPU must be put in to the board to 'revive' it. Here's a linky:
http://www.theinquirer.net/?article=8250

But my rig doesnt boot when I put the fsb above 134
I can put the cpu very high but as soon as I fiddle with fsb it is a no go.

Strange that I can boot at silly 134 but not at 135.
That has nothing to do with the corrupted bios Im afraid