I´ve enter by telnet just fine...
entered first lab : r1r2ser
Username : cisco
Password : cisco
and here´s the result:
--------------------------
Entering R1R2 Labs
Go to
http://www.r1r2.com for help.
E-mail to:
[email protected]
Please enter a lab type at the prompt below:
r1r2ser (2-router serial labs, free!)
r1r2fra (special access only)
r1r2ios (IOS command line, free!)
Note: The ccie rack has moved and is no longer from this screen
User Access Verification
LabType:r1r2ser
Entering R1R2 Labs
See
http://www.r1r2.com for support
LabType selected: r1r2serial
Please log in using your r1r2 username and password.
User Access Verification
Username: cisco
Password: Trying R05-1 address #1 ... Open
W E L C O M E
You have connected to an r1r2 v-lab router console using a reverse telnet
session. Use the EXEC escape sequence to return to the EXEC prompt of
the console server, "ConSvr?>", whenever you want to connect to the other
router in the v-lab. The escape sequence is "control-shift-6", then "x")
Once at the ConSvr prompt, execute "sh sess" or "w" to see what router is
router 1, R??-1. Then, if you haven't done so already, telnet to router 2,
R??-2. After that, use the session number to go back and forth from R1 to
R2 via the console server, i.e. ConSvr1>1 to go to Router1 or ConSvr1>2 to
go to Router2.
To password recover a router, issue a BREAK to power cycle the router, then
issue a second BREAK after the DRAM sizing to get into the ROM monitor, ">".
The BREAK escape sequence is "control-shift-6", then "b". Please see our web
site,
www.r1r2.com, for further details on password recovery.
Press RETURN to get started.
router1>ena
Password:
router1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
router1(config)#
--------------------------
As you can see, had no problem...
Give a try and see for yourselfs.
