slot 1 mounting? anyone know how?

what is the mounting pattern on a slot 1 chip?

1.91" x 1.37" center to center with .125" holes.

ty mota, you have any blocks? if so pm me i need 2 blocks to run in a dually

I do have two slot1 blocks but they are cross drilled aluminum and aren't very good performers, they are also in very bad shape from my experimenting. Danger den still makes a maze1 block for slot a/slot1. The slot version has barbs on the side.

http://www.dangerden.com/mall/Blocks/maze1.asp

I actually used the socket-a version of the maze one on my slot1 cpu with excellent results. I had full load temps of minus 26°C on my p3800e with the use of an 80 watt peltier. I used a c-clamp for the mounting setup. Not sure if you will have enough room on a dual board to do the same.

i was wondering the same question as i have a dual slot 1 mobo. the distance from the mem sticks is about 42mm or 1.69 inches. anyone have pics of a w/blocked dually??

ill have to measuere. i have 2 120mm pelts.