Front USB

got a case (solid multimedia case) and it comes with no instructions, it has front usb/sound but i have no idea how to hook it up..they cable that was attached has a
1 - ground
2 - D
2 - ground
1 - D
1 + D
2 + D
1 + 5V
2 + 5V
no idea where to hook these on my mobo, if u have any idea plz lemme know

You'll need to look in your Mobo manual to see if it supports these features. It should tell you exactly where to plug in to.

ok in my manual it says:

10(GND) 9(NoPin)
8(GND) 7(GND)
6(Data1+) 5(Data0+)
4(Data1-) 3(Data0-)
2(VCC1) 1(VCC0)

so how would i go about hooking this up?

1 - D <-> 5(Data0+)
2 - D <-> 6(Data1+)

and so on.

Equate 1/0 signal markers on the case cable with the 1/2 signal markers on the motherboard, I.E., Board1 = Case0, Board2 = Case1.

Basically, you have two channels, each with:

+5v
Data +
Data -
ground