a7v133-c

havin troble with the fsb. thought it should be 133 mhz. all i get is 114@ 8x = 912 mhz. (7.5 volts) temps are all good. when i go above it flakes. last night i went 5.5 x 133 to see if it was proc. but wouldnt even post. is there a bios update that adresses this issue? would dipswitches provide better results than bios ocing?
some a post a while back about this i believe. would hard drive or memory be the culprit. hd is old compaq 30 gig from original system. " compaq presario 5000us" any suggestions.

well, im not familiar with the board, but from the name i would assume it is 133FSB... what processor are you using in this?

... and i seriously hope 7.5v is a typo