[Justin@JDM]

I have searched but looks like I still can't cut the umbilical cord.

I have a 2.4C (800) with Corsair 512 XMS 2700 memory, ATI 9600 Pro and an Albatron PX845PEV PRO. I have a Thermaltake case with like 8 fans well positioned. The CPU temp right now runs at around 30-35 C.

I am ready to overclock this sucker. The options in the BIOS I have are CPU Voltage (1.525 default). The bus speed (200 default), DDR CPU Ratio, it gives me two options to select 2.00, 2.50. Than I have a DDR Voltage with these options 2.5,2.6,2.7,2.8. Default is set on 2.5.

Can someone walk me through the options I would need to get this sucker to 3.0. Would I need to change any memory speeds or anything. I appreciate the help. You guys are great.

Thanks,

Justin@JDM
www.TeamJDM.com

[iD10t]

just change the bus speed to manual, then increase the bus speed a little at a time to test for stability.
after you find your high speed you can try to see if you are stable with different ram speeds (lower is faster but less stable sometimes), when you do that you could probably up your ram voltage to 2.7.

[Homer]

u should check this thread out if ur having troubles with ur board.