Be careful when removing shims.

Cut one resistor off my radeon 9500np while taking off the shim, severed another resistor. :/ I lost the resistor!

Comp still boots with card. Since I have no hs on it I cant really test it yet.

thats why i use dental floss

That would have been nice to know 2 hours ago

Card still works, I cant find anythign really wrong with it. But I kinda wanna replace the resistor that flew off.

Any Ideas what I should do?

I ran 3dmark and it works, it seems like its dropping a few frames, but no artifacts.

Edit: Actually I think is running fine. Could It be that trace wasnt actually doing anything? Or is my card going to explod with a few hours of usage?

without knowing which one u cut off we cant really tell can u post a pic

if u cant host it ill be happy to

Here is a pic I found on the web.

The big red circle is where I totally cut off a resistor, the smaller one is where i just severed one end of the resistor, but pushed it back down to make contact.

Now you have an idea which ones I cut.

i say if it works fine leave it alone. you were lucky that you didn't have to flush the whole card down the toilet imo

[edit] spelling

Those aren't resistors. Those are capacitors.