Would a basic Water cooling setup fit in....

Ok, im making my ultimate overclockin machine, with chevette heater core, 120mm aluminum fan, pretty small resovoir, 1/2" tubing, and a danner mag3.

Do you think this will fit internally in this case:

http://www.newegg.com/app/viewProductDesc.asp?description=11-130-141&depa=0

Oh yea, for sure.

I'd take out the bottom hard-drive rack, put a caprice heatercore in there, with dual 120mm fans.

Take a look at Giblet Plus' setup, set it up like that, then jsut put your hard-drives above the psu.

Here's my played out picture of my setup:



With that Aopen case, it would be a waste to not use a double sized heatercore. I'd do what sandman reccommended and cut out the 3.5" bays to make room for a big heatercore with dual fans.

Your best option for a heatercore would be a Fedco 2-342 single pass core from a place like www.rockauto.com :

ok thanks.

dguy6789 said:

pretty small resovoir

Click to expand...

If you're going to use a reservoir, you might as well make it a decently sized one connected to your pump inlet. Otherwise, a T-fitting will work out better for you.