Ok, so I've read two ways to apply this stuff. Which is the best?
1) Put a little bit on the core then put on the hsf. This smooshes the little mound of AS5 causing it to spread. This leaves the corners of the proc bare.
2) Put a little bit on and spread across the heatspreader, then apply the hsf.
1) Put a little bit on the core then put on the hsf. This smooshes the little mound of AS5 causing it to spread. This leaves the corners of the proc bare.
2) Put a little bit on and spread across the heatspreader, then apply the hsf.