Running Mushkin on Lanparty

OnDborder · Dec 30, 2004

Well I went and got some Mushkin, http://www.mushkin.com/epages/Mushk...901aff1a42740c0a8010206a0/Product/View/991357.
They have the TCCD chips.
I running at 2367 215x11@ 2225 [email protected] at the moment.

Anyone have some ideas on the rest of those settings in the dram part of the bios?

OnDborder · Dec 30, 2004

220x11@ 2225 with vdimm of 2.8 with cpc enabled or 1t still.
I had some Corsair XMS 3200xl earlier that wouldn't touch 210 with out a little relaxin'..
Soooo much better..

Lon3R · Dec 30, 2004

http://www.ocforums.com/showthread.php?t=329627
jess practically lays the timings out for you . thats what i used.

OnDborder · Dec 30, 2004

"Most of which were tested with my BH-6", Jess.. http://www.ocforums.com/showthread.php?t=329627

These are tccd chips. Still waiting for him to post settings suggestions on tccd's.

Thanks..
What ram are you running?

OnDborder · Dec 30, 2004

223 is the tops for the [email protected].

Lon3R · Dec 30, 2004

yea but i used what he siad for each timing on my XBL's which are tccd without a hitch dont use the exact timings leaid out there jus read the captions under each timing

mattspalace · Dec 30, 2004

I just left all the other stuff on auto - changing them didn't seem to make a whole lot of difference.. You should be able to run 250+ FSB with 2.5-3-3-7 timings.

OnDborder · Dec 30, 2004

Matt, ya I should. I wanted to see what the "max" for the tighter,2225, settings would be at 1:1 at 1t. 223 isn't bad.
Edit; until I noticed you running you bh at 240, 2 2 2 11
You must be pumpin' some volts through them babies.

mattspalace · Dec 30, 2004

Oh, that's the Gig of BH-5 I have.. I also have a gig of Mushkin TCCD also.. I just can't decide between the two!!

tommcd64 · Dec 30, 2004

I haven't oc'd or changed the memory settings yet but I have 2 512mb Level I mushkin black ram and it runs fine on this board and several others that I have tried it on.

OnDborder · Dec 30, 2004

mattspalace said:
Oh, that's the Gig of BH-5 I have.. I also have a gig of Mushkin TCCD also.. I just can't decide between the two!!

What kind of voltage do you run on them?

mattspalace · Dec 30, 2004

that was 3.2v. The TCCD really doesn't seem to respond to high voltages like BH-5. It does help, but not as much.

OnDborder · Jan 1, 2005

Well I did get to 240x11 but at 2337, 3vdimm, and 1.68 vcore.

Running Mushkin on Lanparty

OnDborder

Senior Member

OnDborder

Senior Member

Lon3R

Member

OnDborder

Senior Member

OnDborder

Senior Member

Lon3R

Member

mattspalace

I been Dolk'ed Senior

OnDborder

Senior Member

mattspalace

I been Dolk'ed Senior

tommcd64

Member

OnDborder

Senior Member

mattspalace

I been Dolk'ed Senior

OnDborder

Senior Member

Similar threads