After bios flash....Dead mobo??

So here's what happened:

I wanted to fix the temp reading and boot issues with this board and my DTR 3200+, downloaded 9/14 official bios, flashed using winflash after making a backup of stock bios. Flash appeared to go well, prompted a system reboot, powered down. As per DFI's official instructions I pulled the power, pulled batt, cleared cmos, replaced batt and power. I powered back up, and nothing...... I unplugged again, removed battery/reset cmos again, powered up, nothing. No boot, no post, no activity light. HDD light stays on steadily. WTF! I followed the winflash instructions precisely and was sure to update all blocks. So wtf is going on here.......did I kill my board?

Please help.......I'm a bit concerned as I'm sure you can imagine.

Most likely your BIOS is corrupted. Its a very common occurance. You can either hotflash the chip by using another computer. Or order a replacement and then once that one arrives, hotflash the old one.

There are a number of guides on the Inet about this topic:

http://www.ntcompatible.com/story19426.html