Lanparty Ultra D and Corsair Value Ram - What BIOS? HELP

I just got an ULTRA D in that I bought on some forums. It has the 6.00pc or pg bios loaded on it.

I am using my old venice that I had at 2.8ghz on air in my old Asus A8V deluxe, but i cannot overclock a BIT OVER STOCK!!!!!

It is really frustrating and the only thing I can think of is the bios as I've tried every settting and my powersupply is upgraded to an ANTEC SP500, my cooling went from an XP90 to a Big Typhoon, and everything else seems prime for overclocking except it wont, AT ALL.


Any help or suggestions would be greatly appreciated.

I tried these settings from the stable settings thread in hopes that it would work.

CPC: Enabled< This setting does not show on the 310p bios w/t SD Chip and it is always 1T
Tcl: 2.5
Trcd: 4
Tras: 8
Trp: 4
Trc: 11
Trfc: 16
Trrd: 2
Twr: 2
Twrt: 2
Trwt: 2
Tref: 3120
Twcl: 1

Bank int.: Enable
Skew increase
Skew control: 255 +
Drive strength: 7
Data strength: 4
Max. Async: 7ns
Read Preamble: 5ns
Idle Cycle: 256
Dyn. Counter: Enable
R/W Bypass: 16x
Bypass Max: 7x
32Bit Gran.: Disable


LDT/FSB: 3x
LDT: 1.2v
Chipset: 1.5v
VDimm: 2.9v
Vid Card: 100mghz
Cool & Quiet: disabled
PCIex Maximum Payload size: 256
DFI Logo: Disabled



I cannot even run prime95 torture test for a SINGLE MINUTE without getting an error. This is COMPLETELY stock minus those settings.

set the read preamble higher perhaps

Be sure to do a complete clearing CMOS clear/reset .

That didn't seem to help anything. I can't even leave everythign at stock/auto without it BSOD'ing or failing prime

Fresh install of windows
Updated bios 6-23/3
Even changed the ram to Corsair XMS 3200c2

Still wont run prime95 at stock settings. I am going nuts.

It's just smart to do the clear CMOS since it was someone else's board.
I'd look up your ram in the stable settings thread or in the DFI NF4 stable settings thread.

You should get tons of help in those.

If you're still having troubles, then post all your specs....RAM, PSU, VGA, Bios revision, etc.

Use this chart for handy references in your work if you'd like.

Here's my stable settings for 2.8ghz on a Venice

I'm sorry I didn't read better that you have the Corsair Value Ram...sorry.

I'd go with the 5-10-1 or 6-23-3 bios for that ram. For more options: DFI NF4 Bios (at DFI-street)

Here's Tmod's Bios CD thread in case you don't have a floppy (or hate 'em).

Rember to do the complete CMOS clear after a bios flash....