• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

Problem with an Epoxy 8KHA+

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

Shelnutt2

Overclockers Team Content Editor
Joined
Jun 17, 2005
Location
/home/
I recently bought two Epoxy 8KHA+ boards. One booted right up the second did not. There is a red LED, LED3 that stays on. I looked through the manual but was unable to find out about when just LED3 was on. The power on lights on the case are not on nor blinking, and thats all the manual covers.

I've tried a XP2400+ and a XP2000+. Three sticks of ram, two power supplies and One cmos clear(12 days of christmas?:p). ok actually 3 or 4 cmos clears.

I'm stumped. I don't know if this board is dead or not.

Thanks guys!
 
did you get any beep codes?

It sound like the board could be dead.

also try jumping the board instead of turning it on with the switch to see if that is the problem
 
sephiroth_749 said:
did you get any beep codes?

It sound like the board could be dead.

also try jumping the board instead of turning it on with the switch to see if that is the problem

No codes, tried starting with a screw driver, no go. No codes on the LED2.
 
Back