MrSeanKon
Disabled
- Joined
- May 23, 2005
- Location
- See my profile....
-
Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!
ASUS AN8-E v2.0 crashes.....
- Thread starter MrSeanKon
- Start date
OP
MrSeanKon
Disabled
- Joined
- May 23, 2005
- Location
- See my profile....
- Thread Starter
- #3
GKR mainboard is dead........
I will buy a new one later cos I am leaving for vacations for Xmas.
Merry Xmas to everyone
SH0DAN to inform you:
1) This mainboard was Vcore, Vdd and Vdimm modded (the seller done them).
2) The BIOS version was 1013 (from official ASUS site).
3) Mainboard could achieve higher FSBs using different processors and I describe this in Guidemania (I do not know why).
The seller achieved 400 MHz with a single core Opteron....
4) The permanent settings were 10*300, HT ratio = 3X, Vcore = 1.48 - 1.52 Volts (depending on temperature), Vdimm=2.67, 2*512MB Mushkin PC4400, 2.5-4-4-8/2T/synchronous rate, Enermax 465 Watts PSU 20pin, San Diego 3700+, SLK948U copper heatsink.
I could set HT ratio to 4X but it did not help for better performance (I do not play games and care for benchmarking).
I will buy a new one later cos I am leaving for vacations for Xmas. Merry Xmas to everyone
SH0DAN to inform you:
1) This mainboard was Vcore, Vdd and Vdimm modded (the seller done them).
2) The BIOS version was 1013 (from official ASUS site).
3) Mainboard could achieve higher FSBs using different processors and I describe this in Guidemania (I do not know why).
The seller achieved 400 MHz with a single core Opteron....
4) The permanent settings were 10*300, HT ratio = 3X, Vcore = 1.48 - 1.52 Volts (depending on temperature), Vdimm=2.67, 2*512MB Mushkin PC4400, 2.5-4-4-8/2T/synchronous rate, Enermax 465 Watts PSU 20pin, San Diego 3700+, SLK948U copper heatsink.
I could set HT ratio to 4X but it did not help for better performance (I do not play games and care for benchmarking).
Last edited:
