Im having problems getting my E6300 past 2.3Ghz.
My specs are in my sig.
Is it anything to do with the Nforce4 chipset?
Im not expecting anything over 2.8 cos aparently the fsb wall is 400 on my mobo.
I can get it to boot at 1300 on stock cpu volts and lower nb and sb volts.
BIOS settings are as follows (im using the latest BIOS - 0801, also used 0704)
Speeds:
Fsb:1350
Mem:900 5-5-5-15 ... iv tried a few speeds between 800 and 900 but nothing
PCI-e:110 ... tried 100,105 and 115
Voltages:
Vcore:1.4
FSB termination:1.415
Mem:2.2
Nb:1.6
Sb:1.6
Misc:
FSB optimize mode: disabled
Memory " " : disabled
PCI-e spread specrum: disabled
SATA " " :disabled
LDT " " :disabled
CPU:
Max CPUID value limit: disabled
Execute Disable Function: enabled
C1: disabled
thermal control: disabled
speedstep: disabled
Chipset:
Memory remap feature: disabled
PEG link mode: disabled
NB hypertransport: 800mhz
SB " :800Mhz
If anyone can find anything that a can change to get me some more MHz it would be much appreciated.
Thanks in advance
My specs are in my sig.
Is it anything to do with the Nforce4 chipset?
Im not expecting anything over 2.8 cos aparently the fsb wall is 400 on my mobo.
I can get it to boot at 1300 on stock cpu volts and lower nb and sb volts.
BIOS settings are as follows (im using the latest BIOS - 0801, also used 0704)
Speeds:
Fsb:1350
Mem:900 5-5-5-15 ... iv tried a few speeds between 800 and 900 but nothing
PCI-e:110 ... tried 100,105 and 115
Voltages:
Vcore:1.4
FSB termination:1.415
Mem:2.2
Nb:1.6
Sb:1.6
Misc:
FSB optimize mode: disabled
Memory " " : disabled
PCI-e spread specrum: disabled
SATA " " :disabled
LDT " " :disabled
CPU:
Max CPUID value limit: disabled
Execute Disable Function: enabled
C1: disabled
thermal control: disabled
speedstep: disabled
Chipset:
Memory remap feature: disabled
PEG link mode: disabled
NB hypertransport: 800mhz
SB " :800Mhz
If anyone can find anything that a can change to get me some more MHz it would be much appreciated.
Thanks in advance
Last edited: