So I have the wooden case built already and im going to Install all the parts and Finish the project this weekend.
For now here is all my parts I have, Current Setup, and a Stupid mistake
First I will let you guys laugh at my mistake
For future WCers Do NOT Overtighten Danger Den SLI Fittings...
Top: What its supposed to look like
Bottom: What happens if you over tighten. (Threads pop off )
Parts:
Rads and CPUBlock were already purchased earlier.
Inside Phantom:
Whole Setup:
Behind the Rads and how there setup:
CPU Temps:
Idle: 35-37*
Load: 55-60*
GPU Temps: (I had to go Full Cover since they are my first GPU Blocks!! But the Next GPUs will be universal blocks)
Stock
Idle:42-50*
Load: 70-80*
WC
Idle: 32-33*
Load: 40*
Stay Tuned for more updates Through the week and this weekend for the Final look at the Case
For now here is all my parts I have, Current Setup, and a Stupid mistake
First I will let you guys laugh at my mistake
For future WCers Do NOT Overtighten Danger Den SLI Fittings...
Top: What its supposed to look like
Bottom: What happens if you over tighten. (Threads pop off )
Parts:
Rads and CPUBlock were already purchased earlier.
Inside Phantom:
Whole Setup:
Behind the Rads and how there setup:
CPU Temps:
Idle: 35-37*
Load: 55-60*
GPU Temps: (I had to go Full Cover since they are my first GPU Blocks!! But the Next GPUs will be universal blocks)
Stock
Idle:42-50*
Load: 70-80*
WC
Idle: 32-33*
Load: 40*
Stay Tuned for more updates Through the week and this weekend for the Final look at the Case
Last edited: