Hello,
I am completely new to OC'ing. I just built my new system which is by far the fastest I have ever had before. Its a dedicated Home Theater PC which I will do some gaming on.
Here are my current specs;
AMD A8 3870K
ASUS F1A75-V EVO
2x4gb Corsair DDR3 1866mhz chip
Silverstone Tek NTO1-Pro heat sink with 2 80mm fans
My problem is my RealTek LAN controller (builtin) seems to shutoff every 5-6 seconds for about 2-3 seconds then turn on and repeat after overclocking.
ASUS has an automatic overclock feature so I tried that and it OCed to 3488Mhz from 3000. I don't know exactly how it went about this but it apears to have upped the APU Frequency to 109 and multiplier up to 32.
When I manually OCed, I strictly used the APU frequency, kept the voltage setting on auto and got it up to 117 x30 which was 3510Mhz. Everything seemed to be ok though my realtek would shutoff and turn back on...even after I load the defaults the realtek controller still acts up untill I uninstall and reinstall the drivers for it. Then it seems to be ok.
I uninstalled and reinstalled the drivers while the PC was OCed and it would work for a bit and start acting up again
I don't seem to get very far OCing when strictly using the multiplier. Temps are below 55 under load most of the time when OCed. Under load is encoding DVDs and Blurays.
Now is increasing the APU frequency causing the issue?
I am completely new to OC'ing. I just built my new system which is by far the fastest I have ever had before. Its a dedicated Home Theater PC which I will do some gaming on.
Here are my current specs;
AMD A8 3870K
ASUS F1A75-V EVO
2x4gb Corsair DDR3 1866mhz chip
Silverstone Tek NTO1-Pro heat sink with 2 80mm fans
My problem is my RealTek LAN controller (builtin) seems to shutoff every 5-6 seconds for about 2-3 seconds then turn on and repeat after overclocking.
ASUS has an automatic overclock feature so I tried that and it OCed to 3488Mhz from 3000. I don't know exactly how it went about this but it apears to have upped the APU Frequency to 109 and multiplier up to 32.
When I manually OCed, I strictly used the APU frequency, kept the voltage setting on auto and got it up to 117 x30 which was 3510Mhz. Everything seemed to be ok though my realtek would shutoff and turn back on...even after I load the defaults the realtek controller still acts up untill I uninstall and reinstall the drivers for it. Then it seems to be ok.
I uninstalled and reinstalled the drivers while the PC was OCed and it would work for a bit and start acting up again
I don't seem to get very far OCing when strictly using the multiplier. Temps are below 55 under load most of the time when OCed. Under load is encoding DVDs and Blurays.
Now is increasing the APU frequency causing the issue?