Unreal temp with SK-6

hpotter · Apr 28, 2002

I was trying to optimize my computer temps so I figured that I would reseat my SK-6 and change the Arctic Silver. I added a 120mm Panaflo and turned it on. And to my surprise somehow, mbm5 said that my cpu temp is -1 c. I'm running an 1700+ and I'd never seen temps that low except peltier/water cooling. Is this just a fluke or what.

Niloc · Apr 28, 2002

That has to be a fluke. But it sure would be sweet if it wan't!

Illah · Apr 28, 2002

Definetely a fluke, unless your computer room is below freezing...

--Illah

Stryfe · Apr 28, 2002

My CPU temp reading in MBM will occasionally spike to 86C for no reason. It think it's a bug. It's happened at least a dozen times and it's always 86C that it spikes to. It's just there in the High/Low reading when I check it, but the average temp is normal so it didn't spend long there. I think it may be a bug that only effects the high/low reading section.

JFettig · Apr 28, 2002

mine is -57c....... on the diode setting...

parkan · Apr 28, 2002

maskedgeek said:
mine is -57c....... on the diode setting...

Um, are you sure you didn't reverse it?

(Also note that in the pic the voltages are messed up as well)

Unreal temp with SK-6

hpotter

Registered

Niloc

Member

Illah

Member

Stryfe

Member

JFettig

Hey! I showered! Senior

parkan

Member

Similar threads