• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

1/2" over 5/8" tube

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

BigFloppyLlama

Registered
Joined
Apr 6, 2003
The heatercore I bought off of e-bay uses 5/8" inlets and outlets. I have no access to a welder so I'm looking for other options. Its clearflex 60 so it has some give. I was thinking about dremeling off any extra length I don't need, and then bending in the cut to prevent any rough edges from cutting the tube. Then soaking the tubing in hot water and clamping it on. Good idea, bad idea?
 

samcim69

Member
Joined
Apr 4, 2002
Location
uk
i have pushed my clearflex 60 1/2" over a 5/8 barb usin warm water quite easy hope this helps :D