• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

A7n266-e And Vcore Help

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

DKC

Member
Joined
Feb 4, 2002
Hey anyone who has the board I'm just wondering if there is any way to set the vcore in BIOS or do I have to use jumpers?
And if I use jumpers, should I have it on ignore in the BIOS?
 
as of now I left everything defualt.... - with everything as controlled by BIOS NOT jumpers...
 
What are ur settings to get those low temps. what kinda fans u got etc.
 
DKC said:
What are ur settings to get those low temps. what kinda fans u got etc.

Antec SX1040B case
I modded it heavily
with dremel I cut out the front bottom face to fit in two 80MM Antec hydro sleeve fans

I then holesaw'd a 120mm Panaflo H1A blowhole on top...

6 - 80mm fans and 1 - 120mm fan total in the case.

For cpu heatsink I use the Coolermaster HHC-001 HEATPIPE... lapped of course with automotive sandpaper 180grit and AS3 grease.

the chip temp is heavily based on ambient which it usually is 11-12F above case temps so I have had same setting as low as 87F on chip full load and as high as 109F on chip full load - living in the desert is rough!!!

but Panaflo is the ONLY case fan to use! www.caseetc.com has a great deal for them.
 
Back