• Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!

after fitting a pelt

Overclockers is supported by our readers. When you click a link to make a purchase, we may earn a commission. Learn More.

spiritedandy

Premium Member
Joined
Apr 12, 2003
Location
Middlesbrough
hi all

after fitting a peltier to my water system ........seti driver will no longer run .....(not sure why that is !!!)

ive deleted and reinstalled it .....but when i goto set up...

spy opens with the driver .........then the driver quits ends prog ...
with the spy still running .....

im useing clc and been running fine until i added the pelt ???? makes no sence !

no seti :confused: :cry: :cry: :cry:


EDIT baisic i cant get the driver to run ....it just turns off ....
 
Last edited:
OP
spiritedandy

spiritedandy

Premium Member
Joined
Apr 12, 2003
Location
Middlesbrough
found out why

hi all

i have solved th problem it must have been the tec .....

if you double click on spy / client / configure / client control....

it then says stop client when cpu reaches xx degrees....

i just stoped this..........and all is well ......puter reading 5c now .......

everything ok now running seti again :D :D :D :rolleyes:
 

gusgizmo

Disabled
Joined
Aug 10, 2003
Location
Kona, Hawaii
that is strange, how low was the temperature setting for when to turn off seti? or was it just a bug in the software that came out due to the low temps?