Another KT7A-Raid question

[Sketch]

Ok, I have done alot of studying about setting up a raid array (0). But I have one question left. Do you set both drives on IDE 3 master/slave or one one 3 and one on 4 and run both master, or do you run them cable select on the same controler or cable select, one on each controler? Does that make sense? LOL! Just want to do it right the first time and the book doesn't say. Thanks

 

[Nomis]

One cable on ide3 and another cable on ide 4 and set both hard drive to master sounds right. Assume the ide3 and ide4 are the orange connectors=Ultra ATA100/RAID.

 

[Executor]

set one at IDE 3 and one at IDE 4 and run both as master

 

[Sketch]

I'll give that a shot. Thanks!