Building A Resivour

[customrig]

Ok I'm about to build a resivour out of an underground electric box but what should a use to seal the barbs in the resivour?

 

[Bender]

I used super glue because thats what I had. You can use sealing tape or just about any other type of waterproof glue. Superglue was quick and it works great for plastics and porus metal.

 

[Neco]

When I sealed my system I used plain old "goop" the "outdoor" stuff..

I got it form lowes I think... or home depot.


comes in a green tube, I think the pakacge showed an example of sealing a hose and stuff.. this stuff bonds good, and seals good. just make sure and test it after each application has dried. sometimes you might miss something.

 

[IFMU]

Ive actually used both. They both work great. The only problem I ran into was if for some reason I needed to take the barbs off, the super glue was a bis natch to get off. The sealer/epoxy was alot easier.

 

[f155mph]

I used 3500 psi epoxy. That stuff works great!!! I think you can get it at Wal-Mart.

 

[The Overclocker]

drill a hole just smaller then the barbs, screw the barbs into it, take them out, rap them in teflon tape and screw them back in, looks good and is water proof.