Cooling for Celly 1.0a / ST6?

[bartron]

Abit ST6 / Celeron 1.0a / Kingston PC 133 256MB


I am running solid at 1.2G right of the box but would like to bump it up. I know it will go because it has booted at 1.4G but that's all it did was boot. So, I am looking for a good Fan/heat-sink combo (That isn't real noisy) that would work. I had a PEP66 setup on my last system but the wife didn't like the noise. I was hoping to hear from those of you that may have a setup running now that you could brag or rag about. I'm off to start looking now but would really like to know what you think.
Thanks

 

[Yodums]

How much money do you have? I guess noise is an issue. Perhaps the Glaciator II is good for you. Or if you really have that much money, and want the best, then watercooling is the best option. Watercooling is pricey though: 100USD...

Yodums

 

[bartron]

I have seen a few within the $50 range with a DB of 25 or so. Do you what the adverage Noise of a stock fan/HS is? I really don't need speed it's a want so I don't think the wife will be too craxy about water cooling.

 

[ol' man]

An alpha pal 6035 will be sufficient I have found since I own two of them. It also runs very quiet with a panaflo fan at 4000rpm. You could also get the new swifty MCXC370 with a copper base. The copper/Al combo's seem to work best with slow fans.