Fit a Pep66 on Abit KT7A-Raid?

[The Doors]

This is my question, coz I'm planning to upgrade my C2 system.
Thanks for your support

 

[Bender]

I'm not really sure if it will but you can always rig it up and put the fan on top. When I did this for my A7V133 my temps remained about the same. My final solution to the problem was to put the fan on the opposite end of the heatsink and now it clears everything.

 

[The Doors]

Thanks for your support,
I'm also thinking to the ultra thin fan 50x50x10mm coz I've two fan on my Pep

 

[Bender]

The 10mm fans will make the pep66 fit on almost any board. How are your temps with 2 10x50mm fans?

 

[The Doors]

Hi Bender,
I don't know, I'm thinking to this way if Pep don't fit properly with a Delta & Sanyo-Denki, but I remember a test made with the ultra thin fan into the section Heatsink Revws and Tips