HELP!Kinetiz 7B and Duron 800

[dura]

...so i soldered the L1 bridges,removed the jumper which is supposed to "unlock" the FSB or something like that,set the multiplier at 6 (6x133=800),still no boot!set the multiplier to "auto",same thing..put the jumper back,it boots ok,but i even with FSB at 100 i still can't change the multiplier.only when i set the multiplier at 9,in boot screen i see Duron at 700(!!) (7x100).on all other settings it runs normally at 800..any ideas?........

Duron 800
QDI Kinetiz 7B
256 @133
Quantum AS 30 Ultra 100
GeForce 2MX
SB 128

 

[Big Mike]

is the board a KT133 or KT133a chipset board? It sounds to me like your L1 bridges arent connected quite right, when they arent unlocked ok they tend to allow only limited changes to the multiplier setting, it may be that 6x133 is trying to post at 8x133 or something like that...id say redo the L1s again would be your best bet

 

[VIGASE]

Check board revision (upper corner)!
If rev. is 1.0 multiplier jumpers don't work.(You can use only AUTO)
To use "manual multipliers" You need board rev 2.0