How many volts should I put through my 4000+ for 3.0

[Dapman02]

How many volts do I need? right now I am at 1.55 volts and it is still not stable.
Also, do I need the PCI spread spectrum enabled

 

[hank123]

i found on my 3600+ that if i backed off the volts a little it was better. try to back them off. u may not get 3.0Ghz.

also i disable all the spread spectrums.

 

[Dapman02]

that helped me to get to about 20 minutes orthos stable, alot better than a few seconds. Is it normal for when my memory gets hot, the heat spreader moves around when I grab it.

 

[MCBTunes]

What kind of temps are you getting after 20 mins? Do you have the G1 or G2 4000+?

 

[Dapman02]

What kind of temps are you getting after 20 mins? Do you have the G1 or G2 4000+?

About 45-50 degrees, AS5 still hasn't set in. G1 4000+ I hope to not have to spend 50 bux to get a G2

 

[jiggamanjb]

My 4000 wouldn't hit 3G no matter what I gave it, 2.8 was the max. I bought a 3600 and it hit 2.9 easy...

 

[MCBTunes]

You fellas are better men than I. Mine is stuck at 255x10.5

 

[Firestrider]

I was only able to keep my 4000+ stable at 3Ghz at 1.62v full load, but temps got too high (~57*C) so I put it back down to 1.4v at 2.8Ghz full load. I'm able to run 3dmark06 at 3.2ghz at 1.62v but it's not ORTHOS stable.