- Joined
- Mar 9, 2001
- Location
- Queens, NY
wire up a 6 pin switch? part number 275-0614 on the rad shcak
-
Welcome to Overclockers Forums! Join us to reply in threads, receive reduced ads, and to customize your site experience!
how to....
- Thread starter phiber
- Start date
- Joined
- Nov 22, 2001
- Location
- Blacksburg, Virginia, USA
That's a little to general, what exactly do you want to do. If you want connect wires to a 6-pin switch solder them.
OP
- Joined
- Mar 9, 2001
- Location
- Queens, NY
- Thread Starter
- #3
I have a two position six pin toggle switch. The center posts are longer then the others on the outside. And I want the toggle to turn on/off the power to my rheostats.
Last edited:
- Joined
- Mar 13, 2002
- Location
- Greensboro NC
It's a DPDT(double pole double throw switch). If you have 2 rheostats, you can wire 1 to each outer pin on each side. Next, solder the power (or ground depending on circuit methodology) to both center pins. Mount the switch and you're done. Remember, the on position is normally away from the outer wires for mounting.
Similar threads
