It Leaks !!!

[WarriorII]

Spent some time today @ home w/ my sick kid, and worked in some time to fiddle w/ my H20 rig I'm building.
Well... It's a Swiftech BareBones system. and the stupid 90 degree fittings leak !
And to top it off...I don't have enough hose!!
So, now tomorrow I get to go out and try and find about 3ft. of hard hose, so I can make it the "Correct"length. Had everything measured out, plugged it in and Drip, Drip Drip
Or go find some plastic fittings to replace ALL the connectors with.

Any one run into this B4?

 

[Colin]

Where are the fittings leaking from, the quick connect?

 

[Ploaf]

If it's leaking around the tubing... Double and triple check to make sure that you have the tubing inserted all the way into the fitting. It can seem like it without always being in there and it's a very easy mistake to make. If it is in all the way you could probably get away with replacing the o-ring on the offending fitting. A damaged oring could cause this problem too.

 

[WarriorII]

Yes, it's leaking from the quick-connections.
On 2 of them, they were NOT instered all the way.
Now I can't get the water block to sit on the cpu correctly. Used all the hose.