Iwill KK266 rev.1.2 help

[bruce]

Iwill used to have an FAQ answering the question as to which resistor was the problem (8.5 multiplier prob.) for kk266 rev.1.2 boards. I'm concerned since I have a 1.2 board, but I hate to have to RMA the sucker and be without a system for a while, they took down the FAQ at the Iwill/Support site for the kk266, I'd like to know if any of you saved the FAQ page or if you know what the resistor is, I'm about to leave town for a while and if I'm gonna RMA it, now would be a good time, thanks...

 

[FunkyTechnician]

Bruce,

I know that fullon3d is now defunct but as far as I know they will continue to host the Iwill FAQ, try this link Iwill FAQ ; it should work, I just tried it out.

Most likely if you bought your mobo lately it shouldn't be one of the defective ones so I wouldn't worry about it.

Amiel

 

[bruce]

Thanks, bought it in late April, haven't OCed it yet cause temps are kinda high, the fan on my GeForce DDR went out and the temps went up, waitin on a blue orb, decided since I was going to be out of town now would be a good time to make sure... haven't worried till now cause with school in session I couldn't afford to be without a PC even for a little while...

 

[bruce]

my 1.2 is A-OK, bookmarked the Full-on-3d page, thanks, can't wait to try some overclocking this summer, again THANKS!!!