While waiting for Alpha Pal 6035 delivery I've been trying to see what this thing might do. The only success I've had is to 1000. Very disappointing. At 1050 I can post and run WinMe until it locks up. At 1100 it will post and immediately shut down. What settings should I try in the WZ bios? Specifically:
CPU FSB/PCI clock?
CPU FSB Plus?
CPU power supply
-Core?
-I/O?
Fast CPU Command Decode?
CPU drive strength?
Enhance chip performance?
Force 4-way interleave?
Enable dram 4K-page mode ?
Dram Clock?
I've only had limited success changing the multiplier factor. Any thing over the 100/33 setting for the clock doesn't want to work. Any special settings for RAM? Temps running at 1000 are 30-40C.
I am running with a Netgear 10/100 card (FA310TX) that I've tried with and without. Didn't seem to matter.
Thanks in advance, Scarzo
CPU FSB/PCI clock?
CPU FSB Plus?
CPU power supply
-Core?
-I/O?
Fast CPU Command Decode?
CPU drive strength?
Enhance chip performance?
Force 4-way interleave?
Enable dram 4K-page mode ?
Dram Clock?
I've only had limited success changing the multiplier factor. Any thing over the 100/33 setting for the clock doesn't want to work. Any special settings for RAM? Temps running at 1000 are 30-40C.
I am running with a Netgear 10/100 card (FA310TX) that I've tried with and without. Didn't seem to matter.
Thanks in advance, Scarzo
