I'm building my new comp right now and I was rolling along sleeving cables, and just as I had taken the two wires out of the PWM cable on my MCP35X someone popped in to ask me a question. 10 minutes later I had forgotten which order the wires went in.
I thought I remembered the Blue wire being towards the middle and the Green wire being on the outside. I also found a picture online where it looked like that was the case, but it wasn't a very good picture.
This is what I have it like right now. The green wire is towards the outside, or towards the right if you are looking down on the connector looking at the side where you can see the four pins.
Can someone that owns one of these either confirm or tell me I'm wrong that this is how the wire should be? Thanks.
I thought I remembered the Blue wire being towards the middle and the Green wire being on the outside. I also found a picture online where it looked like that was the case, but it wasn't a very good picture.
This is what I have it like right now. The green wire is towards the outside, or towards the right if you are looking down on the connector looking at the side where you can see the four pins.
Can someone that owns one of these either confirm or tell me I'm wrong that this is how the wire should be? Thanks.
Last edited: