Modded p3 to work on PPGA(not FC) 810mobo...need help with vidpin.

[Ruiner]

This was the cpu that was replaced by the tuey in my main box.
I had a celly [email protected] on an 810 board for my work box.
I used Tom's article: http://www6.tomshardware.com/cpu/00q1/000229/index.html

After these mods the 700 works great at default speed, but I used to run it at 933. Unfortunately, the mobo only allows Vcore up to 1.75, and this cpu needs 1.85 to run at 933. The mobo does have a 133/33 fsb/pci setting to shoot for (the other one is 124/44....my HDD hated that).

So, which pins to get 1.85?

 

[deez]

What is the default voltage and stepping of your CPU? We cant help you unless we get more info. Maybe the following article will also help http://www.overclockers.com/tips630/index02.asp

 

[Ruiner]

It's a cBo, Default Vcore is 1.65 I think.

 

[Ruiner]

I checked that article...for cBo's, the only pin mod is straight from default to 2.05. They don't list any settings in between, and my mobo only offers default or default+5% (with a jumper) settings.
Does anyone know how to get 1.85?

 

[deez]

I did it with my cel 566 but I cant remember cuz it was a while back VSS to Vid3 maybe

remember you can always shoot for higher then lower your voltage too