My setup :)

[csidd]

With that many IDE's I dont think you could do much better wiring.

Take those wires and sleeve them. It makes a HUGE difference in appearance. Frozen has what you need. I just sleeved my PS and things look tight! I'll attach them as I don't know how to post them in my post (a little help?)

The heater core in the bottom of the case is nice. You have the bottom cut out to vent. The only problem is that it appears you leave it on your carpet. Why don't you try lifting the case off of the carpet? If you set it on a milk crate or or something similar. It might give your core more room to breathe and lower temps. Either way things look good.

 

[crimedog]

that does look nice, i love tight wiring... grr
i'll probably end up doing it this week, i have sleeving materials lying around.

 

[E-Licious]

sorry for the late responses, i was skiing

off-topic, but where'd you go? I'll be leaving for CO tomorrow. Breckenridge and Vail. It's been a few years since I was out west. Looking forward to it.

 

[Giblet Plus!]

This is all in my enermax case (knock off of the thermaltakes)

Actually, Enermax had the design before thermaltake, although it's actually produced by Casetek.

 

[crimedog]

E, i was at killington. the conditions were poor, the week before i went it was in the 50s and raining quite icy and not many trails open. i've heard the it's super nice out west though! jealous

interesting that this case isn't actually the knock-off after all...

 

[Buhammot]

Well in my case.. i hid 90% of my wires on the other side of the mobo and between the back side panel area. i think you can see like 5 wires, and only 1 actually invading the airspace...