need help with a7v settings

[fisheadtony]

i have a duron700 and a7v i need help with settings on motherboard to o/c where do i begin to set dip sw,and voltage setting on board. i did the pencil trick already but im new this board. i have a abit kt7raid with tbird750@950.. but im not sure where to start with this board settings. any help would be greatly aprcetive. or website or link on this. thanx!!!!

 

[Rob Cork]

You can set your multiplier dipswitches to whatever you want, and as long as the fsb switches and the JEN jumper are both set to jumperfree mode you can still use jumperfree mode with the new multiplier. If you want to go in jumper mode (some people say it's more stable, I haven't noticed a difference) just do what the manual says. Watch your temps - as long as they stay around 50C then you can take it to 1.85, no probs (just make sure you don't go above 60, though even that's getting too high for my liking). Try to keep below 50, aim for 40-45. It can be done! Good luck, and make that duron scream! ;-)